DIY jewelry box
Wooden Box Repurposed Into Jewelry Holder
I love old wood. There’s something about it that immediately attracts me. I don’t know if it is the feeling that I might be holding old history and that it must contain a story or that I just find it intriguing. I have a lot of items in my home that I have purchased that feature repurposed old wood. I’ve picked up boxes, crates, benches, a framed chalkboard and others along the way (see some pics of items below).
I found an old wooden box at a tag sale for $4, so without a plan bought it. I had it for a while and tried to think of uses. I used it as a purse holder and then a holder for unused picture frames, and then it just sat empty. Finally, I decided that it would make an awesome jewelry holder. I had necklaces hanging one on top of another always getting tangled, some jewelry in a jewelry box and some on a shelf. Now, this could be a place where it is all together and I can actually see it. So I went to Home Depot and got some small nails, a piece of chain and some hooks. This is where the “imperfect” part of my crafting comes in. Home Depot had the chain in silver, but not the nails and hooks, those were only in gold. I didn’t prefer them in gold, but was anxious to get the project done because it was, after all in my mind. I screwed two eye hooks on the back in the center, but towards the end of the box and attached some picture hanging wire. Then hammered two picture hooks in the wall so the box would hang evenly on two sides providing more stability than just a center hook. Then I counted my necklaces and bracelets and screwed in the screw eye hooks and tapped in the nails. I used the screw eye hooks for the necklaces and the nails for the bracelets and then hung my dangling earrings in pairs from the chain. You will see more imperfection if you look closely, I didn’t take time to measure out evenly so some don’t line up, but you can’t even tell with all the jewelry on because the necklaces and bracelets are different lengths. And there you have it….a new jewelry holder and it only cost me $13.00 to make!